Water Tank - GE GFT14 Owner's Manual & Installation Instructions

Care and cleaning

Water Tank

REMOVE THE CONDENSED WATER IN THE TANK AFTER EVERY DRYING CYCLE.
NOTE: If drain hose is installed, emptying the water tank is not required. See the
CONNECTING THE DRAIN HOSE section in the Installation Installations of this manual.
• Pull out the water tank.
When removing the water tank from the product, hold it using both hands
as it is heavy and take care not to spill any water inside the tank.
• Remove the condensed water inside the water tank.
To avoid over filling, which could lead to water leaking outside the unit,
make sure to drain the water left in the water tank after each cycle.
NOTE: When the Empty Tank indicator light is on, the dryer will not operate
until the tank is emptied and the indicator has been cleared. Press the Start
button and the indicator light will turn off and the dryer will resume the cycle.
Condenser
THE CONDENSER SHOULD BE CLEANED ONCE PER MONTH.
• Open the condenser compartment cover.
• Unlock both locking tabs.
• Remove the condenser.
• Clean the condenser completely by allowing tap water to flow through it.
NOTES:
• Make sure to clean your condenser once per month to prevent degradation
of the dryer's performance.
• When assembling the condenser after cleaning it, make sure the locking tabs
are set to the lock position. Never run the dryer without the condenser
installed.
10
Unlock
Drain hole
on drawer
bottom
49-90571 -1