Connecting The Drain Hose; Water Tank - GE DCCH480EK Owner's Manual & Installation Instructions

CONNECTING THE DRAIN HOSE

DRAINING WATER WITHOUT USING THE

WATER TANK

You can use the dryer without using the water tank by
following the procedures below.
CONNECTING THE DRAIN HOSE
The Dryer can pump the condensed water outside of the
DRYER directly with drain hose provide.
The procedures to connect the drain hose are as follows.
1. Disconnect the drain hose A.
2. Connect the drain hose A to
the other hole.
3. Connect accessory hose B
(long drain hose) adjacent to
hose A.
CAUTION:
r When connecting hose B, take care that the height of
the hose does not exceed 4 ft.
r After connecting the drain hose, you can now directly
drain the condensed water to a standpipe or washstand.
Installation Instructions
A
A
B
17
CONNECTING THE DRAIN HOSE (CONT.)
1. Over the edge of a wash basin: The drain hose must be
placed lower than 4 ft. If the end of the drain hose needs
to be placed above the ground, we recommend a height
of 3 - 4 ft. To keep the drain hose spout bent, use the
supplied plastic hose guide. Secure the guide to the wall
with a hook or to the tap with a piece of string to prevent
the drain hose from moving.)
Drain hose
Hose guide
2. Assemble the drain hose and the hose guide and fix
them with the cable-tie.
CAUTION:
the standpipe any further than 4 inches. Pushing
the drain hose further in the standpipe can cause
leaking.
Cable Tie
Do not push the drain hose in