GE GFT14 Owner's Manual & Installation Instructions page 18

CONNECTING THE DRAIN HOSE
DRAINING WATER WITHOUT USING
THE WATER TANK
You can use the dryer without using the water tank by
following the procedures below.
CONNECTING THE DRAIN HOSE
The dryer can pump the condensed water outside of
the DRYER directly with drain hose provide.
The procedures to connect the drain hose are as
follows.
1. Disconnect the drain hose A.
2. Connect the drain hose A to
the other hole.
3. Connect accessory hose B
(long drain hose) adjacent to
hose A.
• When connecting hose B, take care that the height of
the hose does not exceed 58" (147 cm).
• After connecting the drain hose, you can now
directly drain the condensed water to a standpipe or
washstand.
18
Installation Instructions
Back
View
A
A
B
CONNECTING THE DRAIN HOSE
(CONT.)
4. Over the edge of a wash basin: The drain hose must
be placed lower than 58" (147 cm). To keep the
drain hose spout bent, use the supplied plastic hose
guide. Secure the guide to the wall with a hook or
to the tap with a piece of string to prevent the drain
hose from moving.
5. Assemble the drain hose and the hose guide and fix
them with the cable-tie.
Hose Guide
Drain Hose
Cable Ties
Do not push the drain hose in the standpipe any further
than 4" (10 cm). Pushing the drain hose further in the
standpipe can cause leaking.
58"
(147 cm)
Max.
49-90571 -1