GE GFT14 Owner's Manual & Installation Instructions page 6

Table of Contents

Advertisement

Available languages

Available languages

Getting started
D
Level
E
Damp
Alert
F
Timed
Dry
G
My Cycle
Hold to Set
H
Ext
Tumble
6
Level
The sensor continuously monitors the amount of moisture in the load. When the moisture in
your clothes reaches your selected dry level, the dryer will stop.
NOTE: Sensor dry Level can be used with all cycles except Timed Dry, Air Fluff, Rack
Dry, Warm Up and Dewrinkle.
Ex Dry Use for heavy-duty fabrics or items that should be very dry, such as towels.
Dry
Use for normal dryness level suitable for most loads. This is the preferred cycle
for energy saving.
Damp
For leaving items partially damp.
Damp Alert
This option causes the dryer to beep when clothes have dried to a damp level. Remove
items that you wish to hang dry. The Damp Alert will only beep when this option is selected,
and the dryer will continue to dry.
Removing clothes and hanging them when they are damp can reduce the need to iron some
items.
Timed Dry
1. Select the drying time by pressing the Timed Dry button. Rotate the knob to increase or
decrease the time in 10-minute increments up to 2 hours and 30 minutes.
2. Select the dry Temp.
3. Close the door.
4. Press Start/Pause.
My Cycle
Set up your favorite combination of settings and save them here for one touch recall. These
custom settings can be set while a cycle is in progress.
To store a My Cycle combination of settings:
1. Select your drying cycle.
2. Change Temp and Level settings to fit your needs.
3. Select any drying options you want.
4. Press and hold the My Cycle button for 3 seconds to store your selection. A beep will
sound and the button will light up.
To recall your stored My Cycle combination:
Press the MY CYCLE button before drying a load.
To change your stored My Cycle combination:
Repeat steps 1–4.
Extended Tumble
Minimizes wrinkles by adding approximately 2 hours of no-heat tumbling after clothes are
dry.
The estimated time remaining display will show "END".
The extended tumble time does not get added to the cycle time on the display.
49-90571 -1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents