Table of Contents
Advertisement
3.10
Load Setup Defaults
This op tion will cause the CMOS RAM to be loaded with de fault setup val ues as signed by the
fac tory. These are usu ally val ues that were de ter mined to give a higher level of per form ance along with
re li able op era tion.
3.11
Password Setting
This op tion al lows the set ting of the se cu rity pass word. Press ing en ter at the pass word prompt
dis ables the se cu rity func tion com pletely.
3.12
IDE HDD Auto Detection
This func tion al lows mod ern IDE fixed disks to be used to their maxi mum po ten tial by
in ter ro gat ing the driver as to its pre ferred con figu ra tion of tracks,heads, and sec tors; and auto mati cally
load ing these pa rame ters into a "user de fined" hard disk type.
3.13
Save & Exit Setup
This func tion writes all changes to CMOS RAM and re starts the sys tem.
3.14
Exit without Saving
This op tion ex its setup with out sav ing any changes made and then re starts the sys tem.
030530
WinSystems - "The Embedded Authority"
EBC-LP OPERATIONS MANUAL
Page 3-21
Advertisement
Table of Contents
