Advertisement
Connecting Cisco EHWIC-3G-EVDO-x to the Network
Wireless Access Devices Safety Guidelines and Warnings
The following are guidelines for wireless access devices:
•
•
•
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units. Statement 12
When handling the EHWICs and antennas, wear grounding wrist straps to avoid ESD damage to the
Warning
card. Do not directly touch the backplane with your hand or any metal tool, or you could shock
yourself. Statement 94
Do not operate your wireless network device near unshielded blasting caps or in an explosive
Warning
environment unless the device has been modified to be especially qualified for such use.
Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332
Warning
This equipment must be connected to an indoor antenna only. Statement 373
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Do not touch or move antenna(s) while the unit is transmitting or receiving.
Do not hold any component containing a radio so that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
The use of wireless devices in hazardous locations is limited to the constraints posed by the local
codes, the national codes, and the safety directors of such environments.
Connecting an Antenna to EHWIC-3G-EVDO
Connecting Cisco EHWIC-3G-EVDO-x to the Network
7
Advertisement
