1MRS756375 K
Section 5
5.1
5.2
615 series
Installation Manual
Connecting
Required tools
Only use a screwdriver and insert bits for Phillips (PH 1) cross-recessed head
screws (M3.5) when handling CT/VT terminals (X120) of screw-compression type.
A
A071178 V2 EN
Figure 38:
Screwdriver for CT/VT terminals of screw-compression type
A MAX ∅5.5 mm
B MAX ∅5 mm
A
A071180 V2 EN
Figure 39:
Insert bits for CT/VT terminals of screw-compression type
A MIN 15 mm
Connecting wires
All connections are made on the rear of the case. No soldering is needed.
•
Open the screw-compression type terminals before inserting any wires. By
default the terminals are closed at the time of delivery.
•
Use fine wire in door mounting.
Section 5
Connecting
51