Fujitsu SK-96380-120PMT User Manual page 19

3.4.2 LIN-UART 2 (X9):
Jumper
JP37
(RXD)
JP57
(TXD)
JP40
(RS232/LIN)
JP36
(RTS-CTS)
JP38
(DTR/RTS)
JP43
(LIN enable)
JP45
(LIN master)
JP42
(LIN Vbat)
© Fujitsu Microelectronics Europe GmbH
SK-96380-120PMT User Guide
Chapter 3 Jumpers and Switches
Setting Description
1-2 SIN2 is connected to RS232 transceiver
2-3 SIN2 is connected to LIN transceiver
1-2 SOT2 is connected to RS232 transceiver
2-3 SOT2 is connected to LIN transceiver
1-2 X9 Pin2 is connected to RS232 transceiver (T1out)
2-3 X9 Pin2 is connected to LIN transceiver (BUS)
Closed RTS and CTS of X9 are connected
Open RTS and CTS of X9 are not connected
1-2 DTR signal (Pin 6 of X9) is used as reset source
2-3 RTS signal (Pin 7 of X9) is used as reset source
Closed LIN transceiver for X5 is enabled
Open LIN transceiver for X5 is disabled
Closed LIN-UART2 is LIN Master
Open LIN-UART2 is LIN Slave
Closed Pin 1 (LIN Vs) of X9 is connected to Vin
Open Pin 1 (LIN Vs) of X9 is not connected to Vin
Table 3-6: UART2 Settings
- 19 - FMEMCU-UG-960001-15