Fujitsu SK-96380-120PMT User Manual page 21

SK-96380-120PMT User Guide
Chapter 3 Jumpers and Switches
Note:
While a reset signal is asserted the red Reset-LED LD13 is lit.
During normal operation, this LED should be off!
If JP41 (DTR/DTRx) is set, the UART RESET jumper (JP33) and the according DTR/RTS
(JP23 and JP38) jumper have to be set, too.
If the reset LED is steadily on, check the power supply input voltage and the settings for the
reset-generation by UART.
© Fujitsu Microelectronics Europe GmbH - 21 - FMEMCU-UG-960001-15