Fujitsu SK-96380-120PMT User Manual page 35

2) If the programming software should generate a reset signal on RTS or DTR line, refer
to the following jumper list.
Jumper Programming
JP19
UART0
(RTS-CTS)
UART0
JP23
(DTR/RTS)
UART0
JP36
UART2
(RTS-CTS)
UART2
JP38
(DTR/RTS)
UART2
UART0
JP33
(RESET A/B)
UART2
JP41
(DTR /
DTRx)
JP46
(Direct RST)
3) The CPU Mode selection must be set to internal reset vector mode by setting DIP
switch S1 to Off, On, Off, X.
4) Start the 'Flash Memory Programmer 16FX' and connect the UART0 or 1 to your
serial PC communication port. A straight cable connection has to be used.
5) Choose the microcontroller device (MB96F387) as target microcontroller and 4 MHz
for crystal frequency. Then browse to the mhx-file you want to program to the
embedded flash memory of the microcontroller. Press the button "Full Operation" to
start programming.
Note, that the COM port of the PC can be set in the Option 'Set Environment'.
© Fujitsu Microelectronics Europe GmbH
SK-96380-120PMT User Guide
Chapter 7 Programming the internal Flash memory
Setting Description
UART
Closed
Open
1-2
2-3
Closed
Open
1-2
2-3
1-2
2-3
1-2
-
2-3
1-2
-
2-3
Table 7-2: Jumper Settings for reset signal
RTS and CTS of X5 are connected
RTS and CTS of X5 are not connected
DTR signal (Pin 6 of X5) is used as reset
source
RTS signal (Pin 7 of X5) is used as reset
source
RTS and CTS of X9 are connected
RTS and CTS of X9 are not connected
DTR signal (Pin 6 of X9) is used as reset
source
RTS signal (Pin 7 of X9) is used as reset
source
LIN-UART 0 (X5) connected to reset circuit
LIN-UART 2 (X9) connected to reset circuit
No negation for the DTR/RTS signal
DTR/RTS signal is negated
Reset is applied immediately when SW6 is
pressed
Reset is applied when SW6 is pressed >2sec
- 35 - FMEMCU-UG-960001-15