Installing The Batteries; Installing The Electrode Clip; Installing The Ip54 Seal Components - OHAUS ST300 Instruction Manual

EN-6
2.2

Installing the batteries

Remove the battery cover screw using a coin or screwdriver and remove the battery cover.

Insert the batteries in the battery compartment as shown.

Replace the battery cover and tighten the battery cover screw.

2.3

Installing the electrode clip

The electrode clip is an electrode holder that can be placed on either side of the housing.
Attach the clip by inserting the tabs into the recess.

Slide the clip forward to lock in position.

Slide the shaft of the sensor into the clip from above.

2.4

Installing the IP54 seal components

Use the small plastic tool as shown to install the seal components:
STARTER 300 Portable pH Meter