Installing The Batteries; Installing The Electrode Clip; Installing The Ip54 Cover - OHAUS ST300D-G Instruction Manual

STARTER 300C Portable Conductivity Meter
2.2
1) Remove the battery cover screw using a coin or screwdriver and remove the battery cover
2) Insert the batteries in the battery compartment as shown
3) Replace the battery cover and tighten the battery cover screw
2.3
The electrode clip is an electrode holder that can be placed next to the display on either side of
the housing.
1) Attach the clip by inserting the tabs into the recess.
2) Slide the clip forward to lock in position. Slide the shaft of the conductivity electrode into the
clip from above.
2.4
Use the small plastic tool as shown:
1.888.610.7664

Installing the batteries

Installing the electrode clip

Installing the IP54 cover

www.calcert.com
15
10 20
5 25
0 30
EN 5
-
sales@calcert.com