Checking The Meter Software - GE Measurement Sentinel LCT4 User Manual

6.1.2 Checking the Meter Software

To check the meter software, complete the following steps:
1. Turn power on. The display should boot up with a typical cycling procedure.
2. To verify which version of software has been loaded:
to enter the User Program.
a. Press
[ESC]
b. Press the [] key until
c. Press again to enter Main. The display should appear similar to Figure 53 below.
[ENT]
6.1.2a Checking Option Card Version Information
To verify which option card version has been loaded, complete the following steps:
to enter the User Program.
1. Press
[ESC]
2. Press the [] key until
3. Press again to enter Option Cards. The display should appear similar to Figure 54 below.
[ENT]
Sentinel™ LCT4 User's Manual
is highlighted. Scroll to the Versions option and press
FACTORY
Figure 53: Software Verification Screen
is highlighted. Scroll to the Versions option and press
FACTORY
Figure 54: Option Card Verification Screen
Chapter 6. Maintenance
[ENT].
[ENT].
109