Modifying Master/Slave Configuration Files - Digi PortServer CM User Manual

Modifying Master/Slave Configuration Files

The Master PortServer CM must contain references to the Slave ports. The configuration described earlier
should be followed with the following exceptions for the Master and Slaves:
Parameter
conf.eth_ip
conf.eth_ip_alias
conf.eth_mask_alias
all.socket_port
all.protocol
Configuring the PortServer CM
Value for this Example
Ethernet Interface IP address.
An example for this value is: 20.20.20.1
Secondary IP address for the Ethernet Interface (needed for clustering
feature).
An example for this value is: 209.81.55.110
Mask for secondary IP address above.
An example for this value is: 255.255.255.0
This value applies to both the local ports and ports on slave PortServer
CMs.
An example for this value is: 7001+
Depends on the application.
An example for this value is: Socket_ssh or socket_server
2-19