Hair Trimmer Attachment - Silvercrest SHBS 5 A1 Operating Instructions Manual

Comb attachment for the beard trimmer attachment
The comb attachment
15 mm/18 mm).
♦ Attach the comb attachment
it down.
♦ To remove the comb attachment

Hair trimmer attachment

NOTE
► Any hair to be cut should be clean and dry.
► Brush the hair carefully through to remove any knots.
► Place a hairdressing cape or cloth around your neck and throat to avoid cut hair ends
falling inside your collar.
► Start by setting the comb attachment
cutting the hair.
► Please note that the corresponding cut length will only be achieved if the slide switch
is set to position 3 and the appliance is being held at right angles to the skin surface.
♦ Switch the hair and beard trimmer on by pressing the ON/OFF switch
♦ Run the hair and beard trimmer slowly through your hair.
♦ Hold the appliance so that the comb attachment
♦ Always cut from your neck towards the top of your head, or from your forehead and temples
upwards towards the middle of your head.
♦ Use the hair trimmer attachment
♦ You can use the slide switch
SHBS 5 A1
has settings for 6 diff erent cut lengths (4 mm/6 mm/9 mm/12 mm/
12
from the front onto the beard trimmer attachment
12
press it forwards off the appliance.
12
to a longer length and reduce this in stages while
11
without the comb attachment
2 to fi nely adjust the cut length in three steps.
3
.
is as fl at as possible.
11
to cut the hair very short.
11
GB
IE
and press
7
2
11