Installing The Hp Configuration Utility; Placing The Hp Bt1300 Into Configuration Mode Or Firmware Upgrade Mode - HP bt1300 User Manual

Installing the HP Configuration Utility

1. Load the hp bt1300 Installation CD into the CD-ROM
drive of your computer. The CD should start
automatically and display a menu.
NOTE: If the CD fails to start automatically, click on the
Windows Start button, select Run, type D:\setup.exe, and then
click on OK to begin the installation process.
2. From the CD menu, click on Install Configuration
Utility to begin the installation
process. When the Welcome
window appears, click on Next
to continue the installation
process. Follow the prompts to
install the software.
NOTE: To exit the installation
process at any time before the
installation is complete, click on
Cancel to stop the installation
process.
Placing the hp bt1300 into Configuration Mode or Firmware Upgrade
Mode
Press and hold the test button for at least five seconds until the bi-colored LED cycles between green
and amber to indicate that it is in the configuration mode. After the hp bt1300 configuration is
complete, the device will automatically reboot. After rebooting, the device will return to a ready state,
indicated by a solid green LED (refer to Chapter 5 – Troubleshooting for detailed LED status light
descriptions).
NOTE: You cannot print while the hp bt1300 is in configuration mode.
4- 2 Configuring Your Printer Adapter