Verifying Bluetooth Communication - HP bt1300 User Manual

Verifying Bluetooth Communication

Verify Bluetooth activity between your sending device and the hp bt1300 (the blue LED will be
solid blue when the hp bt1300 is connected to a sending device). To ensure Bluetooth
connectivity, the sending device must be within a maximum unobstructed range of 10 meters (33
feet) of the hp bt1300.
Verify Bluetooth communication by going to your Bluetooth network neighborhood to see if the
hp bt1300 and other devices are listed. If you can see other Bluetooth devices, but the hp bt1300
is not listed, perform a cold reset on the hp bt1300 by removing power and then reapplying
power while simultaneously holding down the test button. A cold reset will restore all factory
default settings for the device. If you do not see any Bluetooth devices listed in your Bluetooth
network neighborhood, check to make sure that your Bluetooth software is working properly, or
contact the manufacturer of your Bluetooth sending device.
If you can see other Bluetooth clients in your network neighborhood, but cannot see the hp
bt1300 after performing a cold reset, then contact HP technical support (refer to Chapter 6 –
Where to Get Help for detailed information).
NOTE: The sending device may remember the previous printer name the hp bt1300 was connected to.
When the device names are updated, the device will still be available to print with the old name.
If you can print a test page and have verified Bluetooth communication from the sending device
to the hp bt1300 and still cannot print a job, contact your print application vendor for assistance.
5- 2 Troubleshooting