Table of Contents
Advertisement
Safety and Regulatory Notices
FCC Compliance Statement for United States Users
This equipment has been tested and found to comply within the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio
and television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit other than the circuit bused by the receiver
Consult the dealer or an experienced radio/TV technician for help
Warning
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by
the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment
interface cable with this device. If this equipment has more than one interface connector, do not leave
cables connected to unused interfaces. Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
For European Users
This product is in conformity with the protection requirements of EU Council Directive 89/336/EEC
on the approximation of the laws of the Member States relating to electromagnetic compatibility. The
Hewlett-Packard Company cannot be responsible for any failure to satisfy the protection requirements
resulting from a non-recommended modification of the product.
This product has been tested and found to comply with the limits for Class B Information Technology
Equipment according to CISPR 22/European Standard EN55022. The limits for Class B equipment
were derived for typical residential environments to provide reasonable protection against interference
with licensed communications devices.
For Canadian Users
This Class B apparatus complies with Canadian ICES-003.
Supplementary Information
The product herewith complies with the requirements of the Low Voltage Directive 72/23/EEC and the
EMC Directive 89/336/EEC and carries the CE marking accordingly. This product was tested in a
typical configuration with Hewlett-Packard Company products.
HP Printer Adapter User's Guide
D
D- 1
Advertisement
Table of Contents
Troubleshooting
