Dynojet Power Commander V Installation Manual page 3

FIG.A
FIG.B
Ground
FIG.C
22-020 www.powercommander.com
1 Remove the seat.
2 Remove the fuel tank.
3 Install the PCV in the tail section of the motorcycle (Fig. A). Use the supplied
velcro to secure the PCV in place.
4 Attach the ground wire of the PCV to the negative side of the battery (Fig. B).
5 Route the PCV harness to the left side of the bike and go towards the throttle
bodies.
Unplug TPS
6 Locate the Crank Position Sensor connector under the left hand side cover.
Unplug this connector (Fig. C).
This is the WHITE 2 pin connector.
09-10 Yamaha XT660R PCV - 3