Dynojet Power Commander V Installation Instructions

For 2009 yamaha r6s

Hide thumbs Also See for Power Commander V:

Download this manual

2009 Yamaha R6S

I n s t a l l a t i o n I n s t r u c t i o n s

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

22-001 www.powercommander.com

2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

PARTS LIST

Power Commander

USB Cable

CD-ROM

Installation Guide

Power Commander Decals

Dynojet Decals

Velcro

Alcohol swab

THE IGNITION MUST BE TURNED

OFF BEFORE INSTALLATION!

YOU CAN ALSO DOWNLOAD THE

POWER COMMANDER SOFTWARE AND

LATEST MAPS FROM OUR WEB SITE AT:

www.powercommander.com

2009 Yamaha R6S PCV - 1

Need help?

Do you have a question about the Power Commander V and is the answer not in the manual?

Page 1 CD-ROM I n s t a l l a t i o n I n s t r u c t i o n s Installation Guide Power Commander Decals Dynojet Decals Velcro Alcohol swab THE IGNITION MUST BE TURNED...
Page 2 Crank- wire into the hole of the PCV until is stops and then instructed to do so by Dynojet. It is used to tighten the screw. Make sure to reinstall the rubber transfer crank trigger data from one module to plug.
Page 3 FIG.A Remove the main seat and the passenger seat. Prop the front of fuel tank up. Remove the rubber plug in the tail section near the tool kit. Lay the PCV unit in the tail section and route the harness thru the hole and down the right side of the bike (Fig.
Page 4 FIG.D Plug the PCV connectors in-line of the throttle bodies and main wiring harness (Fig. D). Plug the colored connectors from the PCV into the matching stock connectors. FIG.E Secure the PCV unit in the tail section using the supplied velcro (Fig. E). Make sure to clean both surfaces with the alcohol swab before attaching Bolt the fuel tank back into place and reinstall the seats.