Initial Power On Test - Raymarine CP370 Installation Instructions Manual

6.1 Initial power on test

Once the unit has been correctly installed check that
it is operating correctly.
After powering on, the unit will take approximately
50 seconds to bootup, from powering on through to
normal operation LED status indicator should be
GREEN. If the LED status indicator is not green then
refer to the troubleshooting section of this handbook.
Open the Fishfinder application on your connected
multifunction display and ensure that it is operating
correctly.
Further information
For detailed operating instructions, refer to the
handbook that accompanies your multifunction
display.
Multiple sonar operation
For systems with multiple sonar modules, only one
sonar may operate at any one time.
Before attempting to use the fishfinder application on
your multifunction display, use one of the methods
described in this document to ensure that only one
sonar module is active on your system.
Switching between internal and external sonar
modules
If you want to switch your active sonar module
between internal and external follow the steps below.
1. Power off the active sonar module.
• Internal sonar module is turned off from the
Fishfinder application menu: Menu > Set-up >
Sounder Set-up > Internal Sounder.
• External sonar modules should be turned off at
the power supply.
2. Wait for the No Sounder Source Available
message to be displayed in the Fishfinder
application.
3. Power on the new sonar module.
36
Switching between multiple external sonar
modules
If your system includes multiple external sonar
modules you must complete the procedure detailed
below to ensure only one sonar module is active at a
time.
Note: If your multifunction display has an internal
sonar module, complete the procedure detailed
in Switching between internal and external sonar
modules BEFORE attempting the following:
1. Power off ALL external sonar modules, either at
the power supply or by disconnecting the power
cable from the sonar module.
2. Wait for the No Sounder Source Available
message to be displayed in the Fishfinder
application.
3. Power on the external sonar module that you
want to use.
CP370 / CP470