Heatsink - HP ProLiant BL685c G7 Maintenance And Service Manual

Disconnect the SAS/SATA cable, the SGPIO cable, and the hard drive power cable from the hard drive
6.
backplane.
Remove the hard drive backplane.
7.
To replace the component, reverse the removal procedure.

Heatsink

To remove the component:
Power down the server blade (on page 22).
1.
Remove the server blade (on page 23).
2.
Remove the access panel
3.
To remove heatsink 3 or 4, perform these additional steps:
4.
Remove all hard drives
a.
("Access panel" on page 24).
("Hard drive" on page 25), if installed.
Removal and replacement procedures 32