HP BL680c - ProLiant - G5 Installation Instructions
Proliant bl680c generation 5 server blade installation instructions
Hide thumbs
Also See for BL680c - ProLiant - G5:
- User manual (111 pages) ,
- Specification (35 pages) ,
- Configuration (23 pages)
Advertisement
Quick Links
HP ProLiant BL680c
Generation 5 Server Blade
Installation Instructions
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 452662-002
October 2007 (Second Edition)
Overview
Installation of a server blade requires the following steps:
1.
Install and configure an HP BladeSystem c-Class enclosure.
2.
Install any server blade options.
3.
Install interconnect modules in the enclosure.
4.
Connect the interconnect modules to the network.
5.
Install a server blade.
6.
Complete the server blade configuration.
For definitions of the acronyms used in this document, refer to
"Acronyms and abbreviations" in the server blade user guide.
Installing an HP BladeSystem
c-Class enclosure
Before performing any server blade-specific procedures, install an
HP BladeSystem c-Class enclosure.
The most current documentation for server blades and other
HP BladeSystem components is available at the HP website
(http://www.hp.com/go/bladesystem/documentation).
Documentation is also available in the following locations:
Documentation CD that ships with the enclosure
HP Business Support Center website
(http://www.hp.com/support)
HP Technical Documentation website (http://docs.hp.com)
Installing server blade options
Before installing and initializing the server blade, install any server
blade options, such as an additional processor, hard drive, or
mezzanine card. For server blade options installation information,
see the HP ProLiant BL680c Generation 5 Server Blade User Guide
on the HP website
(http://www.hp.com/go/bladesystem/documentation).
Installing interconnect modules
For specific steps to install interconnect modules, see the
documentation that ships with the interconnect module.
Interconnect device mapping
To support network connections for specific signals, install an
interconnect module in the bay corresponding to the embedded
NIC or mezzanine signals.
Advertisement
Related Manuals for HP BL680c - ProLiant - G5
Summary of Contents for HP BL680c - ProLiant - G5
-
Page 1: Installation Instructions
NIC or mezzanine signals. © Copyright 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. -
Page 2: Connecting To The Network
Installation is shown in the HP BladeSystem c7000 Enclosure. CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade or the enclosure unless all hard drive and device bays are populated with either a component or a blank. Installation is shown in the HP BladeSystem c7000 Enclosure. -
Page 3: Completing The Configuration
Push the device bay shelf back until it stops, lift the right side Prepare the server blade for installation. slightly to disengage the two tabs from the divider wall, and then rotate the right edge downward (clockwise). Install the server blade. Lift the left side of the device bay shelf to disengage the three tabs from the divider wall, and then remove it from the enclosure.