Whirlpool WHAW050BW Use And Care Manual page 13

Room air conditioner
Hide thumbs Also See for WHAW050BW:
Table of Contents

Advertisement

Extend Side Panels
1.
Loosen locking screws
Raise the window to expose the window side panel and panel
frame. Loosen the locking screws so the side panels slide easily.
2.
Extend window panels
Extend each panel to completely fill the width of the
window. Tighten the locking screws when the panels are
fully extended.
Install Window Lock and Sash Seal
NOTE: Attach curtains to the air conditioner before placing the air
conditioner in window.
1.
Insert sash seal
Trim the sash seal to fit the width of the window. Insert the sash
seal into the space between the upper and lower sashes.
1/2"
screws
5/8"
screw
2.
Attach right angle safety lock
Attach the right angle safety lock with a 5/8" hex-head screw.
Install the Chassis into the Cabinet
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
1.
Reinsert air conditioner chassis
IMPORTANT: To prevent damage to the unit, do not push on
the controls or finned coils.
Using two people, lift the air conditioner chassis and carefully
slide it into the cabinet. Let the front of the air conditioner
hang out approximately 6" (15.24 cm). Be sure the chassis is
firmly seated in the back of the cabinet.
2.
Reassemble air conditioner
Insert all screws removed during window installation.
Reattach the front faceplate, front panel, and air filter. Refer
to the "Prepare Air Conditioner for Installation" section for
more information.
13

Advertisement

Table of Contents
loading

Table of Contents