Table of Contents
Advertisement
COM port. The ZigBee parameters (firmware version, operating channel, PAN ID) for the
®
Digi
XBee USB will be displayed in the "Radio Parameters" box. Go to
System > Hardware > Device Manager > Ports
the USB COM port.
5. Any ZigBee devices discovered will be displayed in the "Devices Discovered" window to the
right.
If the utility times out and no ZigBee devices are displayed, you will have to reconfigure the
®
Digi
XBee USB and recompile the sample program once you make sure the RCM4510W is
powered up. The timeout may occur if you are doing development simultaneously with more
than one ZigBee coordinator. Appendix D explains the steps to reconfigure the Digi
USB.
6. Select a device with your mouse pointer and click on the selected device to select that device.
This device will now be displayed in the "Selected Device" area.
7. You are now ready to interface with the RCM4510W via the ZigBee protocol. Try pinging the
selected device by clicking the "Send Ping" button.
User's Manual
on your PC if you need help in identifying
Control Panel >
®
XBee
57
Advertisement
Table of Contents
