None Of The Components Operate; Pump Does Not Operate But Light Does; Poor Jet Action - Jacuzzi J-315 Owner's Manual

14.1 None of the Components Operate (e.g. Pump, Light)
Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Call your authorized Jacuzzi dealer.

14.2 Pump Does Not Operate but Light Does

Press the Jets 1 Button:
1. If no water movement is detected, make sure power is going to the
spa and check the water level. If it does not solve the problem, con-
tact your authorized Jacuzzi dealer.
2. The main pump #1 operates but no water flows to jets. one of the
Jets pumps may not be properly primed. This can happen after the
spa is drained and refilled. Press the Jets 1 button several times,
never leaving the pump on for more than 5 to 10 seconds at a time.
Turn power off and let the air out by loosening the cap on the mas-
sage selector and/or remove the filter (page 20). Make certain you
tighten the massage selector cap and/or reinstall the filter before
turning on spa power and restarting the pump.

14.3 Poor Jet Action

1. Press the Jets 1 button to make certain that jets pump #1 is on.
2. Depress the air control to the "on" position.
3. Check for dirty filter. Clean, if necessary.
4. Make sure all adjustable jets are open (page 24).
J-335/J-345/J-355/J-365 models include filters on their footwell
suction covers that prevent debris from entering jets pump #2,
when operating. These filters must remain in place to protect
jets pump #2 plumbing network. They should be cleaned every 2
months, or when weak pump #2 performance is observed.
Page 37