Advertisement
28
M Magenta fine
29
Y Yellow linear penetrate
30
Y Yellow fine
8:Failure scoreboard and solutions
Listed below is a common approach in the operation of a few common problems.
◇Fault A: The lamp is not working, the bulb is not lit, the fan does not work
Solving 1: Check the power supply or the fuse is burned
Solve 2: The main power connector on the voltage detector
◇Fault B: connect control units, lighting does not respond
Solving 1: After connecting control units, lighting should be working. If it is not
working properly, check the signal cable plugs and wires are connected correctly.
Solve 2: If the lamp is lit display, but the channel does not respond, check the
address code is set correctly and DMX output voltage polarity.
Solve 3: DMX signal problems if your lighting is off,check the input terminal and the
circuit board.
Solve 4: Please change another one DMX controller
Solve 5: Check whether the signal cable near high voltage power lines caused DMX
display board inside the wire damage.
◇Fault C: some channel is not working
Solving 1: stepper motor may be damaged, or the line connecting the
motherboard burned out.
Solve 2: IC driver board on the motherboard may be damaged
9:CLEAN LIGHTS
Must regularly clean the outside of the optical lens focusing the dust。Based on the
number of lamps use a clean environment to determine:Are moist, smoked or the
Advertisement
