Page 1
PSD-63-IP PAR LED PROJECTOR RGBWA-UV FULL COLOUR 6-IN-1 USER’S MANUAL Thank you for purchasing our PSD-63-IP. Please read these instructions carefully before you begin and operate the fixtures according to these instructions to avoid any possible damages and accidents causes by mis-use.
1. Summary Product introduction The LED PSD-63-IP light uses casting aluminum housing, designed in a fashion of hydrodynamic form. Appearance shows. It adopts high power 6-in-1 LED, which refers to single LED is made of R,G,B,A,W,UV 6-IN-1 LED, And long life span, low consumption, good color mixing effect and high brightness are the most prominent features.
6. Display Operation • MENU : access the menu or return to a previous menu option • ENTER: select the current menu option • UP: menu selection or parameter increments • DOWN: menu selection or parameters decrease 7. Menu Tree Level 1 Level 2 Level 3...
Page 10
SC20 Scene 20 CHS3 Chase 3 INFO Information SOFT(Software Vx.x version) POW(Power 100%/80%/50% reduction) LOAD(Load) ST L Setting YES/NO load) PR L Program YES/NO load) SEND(Send) YES/NO Instructions: When enter to the “*” position displayed on the LED, the light will automatically set as master and send data to external.
Page 11
Inverse square law Linear curve Square law S-curve curve curve 6.6 DISPLAY SETTING 1) Press the ENTER button in DISY menu, then enter to the display setting. 2) Press the UP/DOWN button to select ON 2 MINITES OFF 3) Press the ENTER button to escape and save. 6.7 CUSTOM COLOR SETTING 1) Press the ENTER button in CTST menu, then enter to the custom color setting.
6.11 LIGHTING SETTING PARAMETER RESET 1) Press the ENTER button in ST L menu, then enter to the lighting setting parameter reset. 2) Press the UP/DOWN button to select YES. 3) Press the ENTER button to escape and save. Illustrations “ADDR” “CTST” and “PROG” are not reset, the others reset to the underlined value of the word.
The Conversion between 3 pin and 5 pin XLR: If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN cable. 9. Connecting Picture Light connecting picture...
10. Trouble Shooting PROBLEM REASON AND ACTION Check the power connection is co- rrect or not. Please detect the voltage. Power supply is damaged or incorrect The lighting can’t be started normally connected. Call a qualified personnel to fix it. Connection of control board is not correct.