Arctic Cat 2012 DVX 90 Operator's Manual page 96

ATV Operation
Starting A Cold Engine

NOTE: It is very important not to touch or compress the
throttle lever during the starting procedures.
1. Rotate the ignition switch key to the first position (ON).
2. Move the choke lever to the full-choke position (full left).
3. Compress the left-hand brake lever; then press on the starter button.
CAUTION
Do not run the starter motor for more than eight seconds per
starting attempt. The starter motor may overheat causing severe
starter motor damage. Allow 15 seconds between starting
attempts to allow the starter motor to cool.
4. As the engine warms up (approximately 2-2 1/2 minutes), slowly
move the choke lever to the off position (full right). Do not touch
the throttle lever until the engine has run for at least 3 minutes.
5. Run the engine for at least 10 minutes so it is thoroughly warmed
up. If the engine is run for a shorter period of time, the spark
plug may not have reached a high enough temperature to burn
off the excess fuel in the combustion chamber.
CAUTION
If unburned fuel is collected in the combustion chamber due to
lack of running time, spark plug fouling will occur more easily
during the next starting attempt.
Braking/Stopping
Coming to a stop should be a slow, easy process. Always allow plenty
of room and time to stop smoothly. Sometimes quick stops are inevi-
table, so always be prepared. Whether you're stopping slowly or
stopping quickly, do this:
Previous Previous Main Table of Contents Main Table of Contents
1. Compress both right and left brake levers on the handlebars to
apply both the front and rear brakes.
2. If your wheels lock, release them for a second; then apply them
again.
3. Never "ride" the brakes. Even maintaining minimal pressure on
a brake lever will cause the brake shoes to drag on the drums and
overheat the brake system.
Parking
Parking involves following the previous rules for braking; then:
1. After the ATV stops, shift into neutral.
2. Stop the engine using the engine stop switch.
3. Turn off the ignition.
4. If you have to park on a hill, shift the ATV into low gear; other-
wise, try to park only on level surfaces.
5. Engage the brake lever lock.
Dismounting the ATV
After you've followed the procedure for parking, it's time to dis-
mount.
1. Double check the brake lever lock is engaged.
2. Swing your right leg over to the left side of the seat.
3. Step to the ground on the left side of the ATV.
Handling the ATV
(Active Riding Techniques)
Active riding involves moving your body. You must learn to lean and
shift your weight into your turns to maintain control.
Section Table of Contents Section Table of Contents
2012 T-14
Next Next
27