Arctic Cat 2012 DVX 90 Operator's Manual page 688

3. Remove the drain plug from the bot-
tom of the engine and drain the oil
into a drain pan.
4. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil fil-
ter and dispose of properly. Do not
re-use oil filter.
 NOTE: Clean up any excess oil
after removing the filter.
5. Apply oil to the new filter seal and
check to make sure it is positioned
correctly; then install the new oil fil-
ter. Tighten securely.
6. Install the engine drain plug and
tighten it securely. Pour the recom-
mended oil in the filler hole. Install the
level stick/filler plug.
7. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
8. Turn the engine off and wait approx-
imately three minutes. Recheck the
oil level.
9. Inspect the area around the drain
plug and oil filter for leaks.
Previous
70
Front Differential And
Rear Drive Gear Lubricant
(Inspecting/Changing)
Check and change the gear lubricant in
each according to the Maintenance
Schedule. When changing the lubricant,
use approved SAE 80W-90 hypoid oil
and use the following procedure.
 NOTE: To check each, remove
GZ007C
each filler plug. The oil level
should be at the threads of each
plug.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by
733-441A
4. After all the oil has been drained,
Inspect the oil for any signs of metal
filings or water. If found, take the
ATV to an authorized Arctic Cat ATV
dealer for servicing.
Main TOC
removing in turn the drain plug from
each.
install the drain plugs and tighten
securely.
CAUTION
Section TOC
2012 TRV 2011 TRV
CF107B
CF106C
Next