Honeywell SUPER TRADELINE S8610U Installation Instructions Manual page 9

Table 6. Conversion from Johnson Controls CSA — (All), G60, G65, G66, G67, G600, G670 and G770.
Replacement
Control
Terminal
Function S8610U
Main Valve MV
Operator
Main Valve MV/PV
and Pilot
Common
Pilot Valve PV
Operator
Burner GND
Ground (BURNER)
Connection
Transformer 24V GND
Secondary
(unswitched
leg)
Transformer
TH-W *
Secondary
(switched 24V **
leg)
Flame
SENSE *
Sensor
Igniter / SPARK
Sensor
a
CSA code numbers (for example, CSA45A-600R) are equivalent to G600 and use the same wiring information tables.
b
Discard wires between Y79A and module as follows: Red to 3, Black to 2, White to GR. Discard wire between transformer and 6.
c
Discard wires between Y79B and module as follows: White to 3, Black to 1, Brown to GR. Discard wire between transformer and 6.
d
Discard wire between transformer and terminal 5 (G60) or 6 (G600); otherwise, use existing harness for wiring.
e
Important: Remove black jumper quick connect from Remote Sense terminal of S8610U. Cut jumper wire at circuit board and dis-
card.
* IF INSTALLATION DOES NOT INCLUDE VENT
DAMPER WITH PLUG CONNECTION TO MODULE:
1. Connect the "Call for Heat" thermostat wire to the
TH-W terminal.
S8610U UNIVERSAL INTERMITTENT PILOT GAS IGNITION CONTROL
Old
Control
a
CSA45A-60R , G60, G65, G66, G67, G600, or G670
Installation with Lockout Modules as follows:
None (Y79) Y79A module
3 3
GR GR
1 1
GR GR
GR GR
d
2 Y79 THS
No Connection ** No Connection **
e e
4 4
IGN COIL IGN COIL
b c
Y79A module
Y79B MV MV (3)
GR GROUND (5)
Y79B PV PV (1)
GR GROUND
GR GROUND
2 TH-S (2)
No Connection ** No Connection **
e
4 SENSE (4)
IGN COIL IGN COIL
** IF INSTALLATION INCLUDES VENT DAMPER WITH
PLUG CONNECTION TO MODULE:
1. Connect the vent damper's Molex connector to the
vent damper connector (P1) on the module.
2. Connect the thermostat W wire to TH-W.
3. Run wire from switched leg of transformer second-
ary to both thermostat R and S8610U Module 24V
terminals.
9
G770 Procedural Notes
—
—
—
—
—
—
e —
It might be necessary to cut off
the Rajah connector and/or
attach an insulated, 1/4 inch
quick connect.
69-1955