Honeywell SUPER TRADELINE S8610U Installation Instructions Manual page 14

S8610U UNIVERSAL INTERMITTENT PILOT GAS IGNITION CONTROL
PILOT
1ST
OPERATOR
DUAL VALVE COMBINATION
GAS CONTROL
PILOT BURNER/
IGNITER
1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED.
2 ALTERNATE LIMIT CONTROLLER LOCATION.
MAXIMUM CABLE LENGTH 3 FT. [0.9 M].
3
CONTROLS IN 24V CIRCUIT MUST NOT BE IN GROUND LEG TO TRANSFORMER.
4
LEAVE VENT DAMPER PLUG (P1) UNCONNECTED.
5
FOR SINGLE ROD APPLICATIONS: CONNECT JUMPER WIRE TO THE REMOTE SENSE
6
CONNECTOR.
FOR TWO ROD APPLICATIONS: REMOVE JUMPER WIRE BY CUTTING IT AS CLOSE AS
POSSIBLE TO THE BASE OF THE MODULE, DISCARD CLIPPED WIRE, AND FIRMLY ATTACH
THE SENSOR WIRE FROM THE IGNITER/SENSOR ASSEMBLY TO THE REMOTE SENSE
CONNECTOR.
Fig. 5. S8610U connections in a heating system with power-assisted combustion.
69-1955
GND 24V
MV/
(BRN) GND 24V TH-W
MV PV PV
MAIN
COM
VALVE
2ND
OPERATOR
L1
(HOT)
GROUND
PILOT GAS SUPPLY
S8610U
5
ENVIRA REMOTE
COM ™
P1 SENSE
6
AIR
PROVING
THERMOSTAT
SWITCH
2
COMBUSTION
AIR BLOWER
4
RELAY
LIMIT
CONTROLLER
L2
1 COMBUSTION
AIR BLOWER
MOTOR
L2 L1 (HOT)
1
CLIPPED CLOSE
14
SPARK
JUMPER
3
WIRE
TWO ROD
REMOTE
SENSE
JUMPER WIRE
TO BOARD
SENSOR WIRE
FROM IGNITER/
SENSOR
6
M23586