Honeywell SUPER TRADELINE S8610U Installation Instructions Manual page 12

S8610U UNIVERSAL INTERMITTENT PILOT GAS IGNITION CONTROL
PILOT
1ST
OPERATOR
DUAL VALVE COMBINATION
GAS CONTROL
PILOT
BURNER/
IGNITER
1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED.
2 ALTERNATE LIMIT CONTROLLER LOCATION.
MAXIMUM CABLE LENGTH 3 FT. [0.9 M].
3
CONTROLS IN 24V CIRCUIT MUST NOT BE IN GROUND LEG TO TRANSFORMER.
4
ONCE POWERED UP WITH VENT DAMPER CONNECTED, MODULE WILL OPERATE ONLY WITH
5
DAMPER CONNECTED.
FOR SINGLE ROD APPLICATIONS: CONNECT JUMPER WIRE TO THE REMOTE SENSE
6
CONNECTOR.
FOR TWO ROD APPLICATIONS: REMOVE JUMPER WIRE BY CUTTING IT AS CLOSE AS
POSSIBLE TO THE BASE OF THE MODULE, DISCARD CLIPPED WIRE, AND FIRMLY ATTACH
THE SENSOR WIRE FROM THE IGNITER/SENSOR ASSEMBLY TO THE REMOTE SENSE
CONNECTOR.
Fig. 3. S8610U connections in a heating system with an atmospheric burner and vent damper.
69-1955
GND
MV/ 24V
MV PV PV (BRN) GND 24V TH-W
MAIN
COM VALVE
2ND
OPERATOR
4
PILOT
BURNER
GROUND
PILOT
GAS SUPPLY
S8610U
5
ENVIRA REMOTE
COM ™
P1 SENSE
6
WIRING
HARNESS
VENT
DAMPER
THERMOSTAT
2
LIMIT
CONTROLLER
JUMPER WIRE
CLIPPED CLOSE
SENSOR WIRE
FROM IGNITER/
12
SPARK
JUMPER
3
WIRE
1
L1 (HOT)
L2
TWO ROD
REMOTE
SENSE
TO BOARD
SENSOR
6
M23616