Preparation For Wiring 2.5 - Partlow MRC 7000 Installation & Operation Manual

8
FIGURE 2-1
EC1
15 1
8
WIDTH OF COVER
2 19
(65.9 mm)
32
12 5 8
7 1
2
(320.7 mm)
(190.5 mm)
13
13 15
16
Panel cut-out for flush mounting

Preparation for Wiring 2.5

2.5.1 WIRING GUIDELINES
Electrical noise is a phenomenon typical of industrial environments. The following are guide-
lines that must be followed to minimize the effect of noise upon any instrumentation.
2.5.1.1 INSTALLATION CONSIDERATIONS
Listed below are some of the common sources of electrical noise in the industrial environment:
• Ignition Transformers
• Arc Welders
• Mechanical contact relay(s)
• Solenoids
Before using any instrument near the devices listed, the instructions below should be followed:
1. If the instrument is to be mounted in the same panel as any of the listed devices, separate
them by the largest distance possible. For maximum electrical noise reduction, the noise
generating devices should be mounted in a separate enclosure.
2 1
(64 mm)
2
(384.2 mm)
9
32 DIA.(7.1mm)
1
(342.5 mm)
2
( 354 mm)
63.5mm
16
5 mm)
4
2.5"
16
9 1 m