Casio V-R7000 Service Manual page 26

Device ID
NOTE: When the Main PCB is replaced with a new one, be sure to perform this item.
Tap "Device ID".
Read the Device ID with a scanner, or directly
enter the Device ID.
1
NOTE: The ports for the USB scanner are USB
Port 2 to USB Port 4 located on the rear
side. Carefully connect or disconnect the
USB scanner.
After entering the serial number, tap "Set Device
ID".
Tap " " to show the judgment screen, and
then tap the obtained test result.
2
Reg UUID
NOTE: When the IOC PCB is replaced with a new one, be sure to perform this item.
Tap "Reg UUID".
Tap "UUID set". Then the new UUID is written to
the IOC PCB.
(At the time when it is tapped, the frame is
painted in blue.)
1
Tap " " to show the judgment screen, and
then tap the obtained test result.
Closing the Test Application
Tap "Exit"  "Yes".
Delete the test application related data.
1
– 22 –
V-R7000/V-R7100