Hardware Test; List Of Tests - Casio V-R7000 Service Manual

3. HARDWARE TEST

NOTE: When the Main PCB is replaced with a new one
• Be sure to carry out ID registration (Test program → Device ID).
• A OS software is installed in main board for spare parts. Please update appropriate OS
software if necessary.
NOTE: When the IOC PCB is replaced with a new one
• Be sure to carry out UUID registration (Test program → Reg UUID).

3-1. List of Tests

Test items
3-2. Operation Check
Touch panel calibration
Forced power OFF operation check
Sleep state operation check
Backup battery operation check
3-3. Preparation before Testing
3-4. Testing without Using the Test Application
LAN Port
USB 3 Port, USB 4 Port
3-5. Test Application
Installing the test application
Touch Panel
LCD
Backlight
mic/speaker
USB 1 (Left Side)
SD 2 (Left Side)
Head set
Interface on the rear side
HDMI
SD 1 (Back)
USB 2 (Back)
COM 1, COM 2, COM 3
Drawer 5 V
Drawer 24 V
MCR
Dallas key
Device ID
Reg UUID
Closing the test application
3-6. Other Testing
Bluetooth Test
Wi-Fi Test
To be prepared Access Point (with LAN port), LAN Cable (Straight)
To be prepared USB Mouse
To be prepared USB Flash Drive (for Test tool), Test tool
To be prepared USB Flash Drive (for testing)
To be prepared SD Card (for testing)
To be prepared Head set
Monitor with the HDMI input,
To be prepared
HDMI Cable (HDMI-HDMI)
To be prepared SD Card (for testing)
To be prepared USB Flash Drive (for testing)
To be prepared Loopback Connector
To be prepared Magnetic card (for testing)
Carry out when the Main PCB is replaced.
Carry out when the IOC PCB is replaced.
To be prepared Bluetooth Device
To be prepared Access Point (with LAN port)
– 8 –
V-R7000/V-R7100
Remarks