RUGGEDCOM RS416
Installation Guide
• CSA/UL 60950-1 safety approved to 85 °C (185 °F)
Management Tools
• Web-based, Telnet, CLI management interfaces
• SNMP v1, v2 and v3
• Remote Monitoring (RMON)
• Rich set of diagnostics with logging and alarms
Section 1.2
Ports, Controls and Indicator LEDs
The RS416 features various ports, controls and indicator LEDs on the display panel for configuring and
troubleshooting the device. The display panel can be located on the rear, front or top of the device, depending on
the mounting configuration.
Figure 1: Display Panel
1. Port Status Indicator LEDs
LEDs
6. RS232 Serial Console Port (RJ45)
Port Status Indicator LEDs
Ports, Controls and Indicator LEDs
1
2. Display Mode Indicator LEDs
These LEDs indicate the state of each port.
When Status mode is selected, these LEDs indicate when ports are active.
• Green (Solid) = Link detected
• Green (Blinking) = Link activity
• Off = No link detected
When Duplex mode is selected, these LEDs indicate when ports are operating in full or half
duplex mode.
• Green (Solid) = Full duplex mode
• Orange (Solid) = Half duplex mode
• Off = No link detected
When Speed mode is selected, these LEDs indicate the port speed.
• Green (Solid) = 1000 Mb/s
• Green (Blinking) = 100 Mb/s
• Orange (Solid) = 10 Mb/s
• Off = No link detected
2
3
6
3. Mode Button
4. Alarm Indicator LED
Introduction
4
5
5. Power Module Indicator
Chapter 1
3