Serial Ports - Siemens RUGGEDCOM RS416 Installation Manual

RUGGEDCOM RS416
Installation Guide
1
Figure 19: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3

Serial Ports

The RS416 supports serial cards with fiber serial ST (Straight Tip) connectors, RS232/RS485/RS422 DB9 serial
ports or RS232/RS485/RS422 RJ45 serial ports.
Serial DB9 and RJ45 ports can be run in RS232, RS485 or RS422 mode. They can also be ordered with IRIG-B
time code support.
NOTE
On power-up, all serial RJ45 ports default to RS485 mode. Each port can be individually set to RS232,
RS485 or RS422 mode through ROS. For more information, refer to the ROS User Guide for the
RS416.
NOTE
For information about how to connect devices configured to run in RS485 mode, refer to
"Connecting Multiple RS485
All serial ports feature an LED that indicates the current state of the port.
State
Green
Off
For specifications on serial ports, refer to
The following is the pin-out description for ST, DB9 and RJ45 serial ports:
Fiber Serial Port
Figure 21: ST Port
1. Tx Connector 2. Rx Connector
Serial Ports
2
Figure 20: ST Port
1. Tx Connector
Devices".
Description
Link activity detected
No link detected
Section 4.5, "Serial Port
1
1
2. Rx Connector
Section 4.4, "Fiber Optic Ethernet Port
Specifications".
2
Chapter 3
Communication Ports
2
Section 3.4,
19