Speaker Connections - Magnadyne M9000 Installation And Operation Manual

Installation Procedure

Speaker Connections:

Note: Every speaker has a positive (+) and
a negative (-) connection terminal, there-
fore every speaker must have two wires
connected to it. To properly connect the
speaker system to your new Magnadyne
radio, you must have a + and - wire com-
ing from every speaker to connect to the
unit.
If you are connecting 2 speakers, you
should have 4 wires to connect. If you are
connecting 4 speakers, you should have 8
wires to connect.
Wiring Four Speakers:
(Fader Control Operational)
Brown Wire:
Connect the brown wire to the Left Front
speaker "Positive" wire.
Orange Wire:
Connect the orange wire to both Left
speaker "Negative" wires.
Green Wire:
Connect the green wire to the Left Rear
speaker "Positive" wire.
Gray Wire:
Connect the gray wire to the Right Front
speaker "Positive" wire.
White Wire:
Connect the white wire to both Right
speaker "Negative" wires.
Blue Wire:
Connect the blue wire to the Right Rear
speaker "Positive" wire.
6
Wiring Two Speakers:
(M9000 Only)
(Fader Control Deleted)
Brown Wire:
Connect the Brown wire to the Left speak-
er "Positive" wire.
Orange Wire:
Do not connect this wire. Tape it Off.
Green Wire:
Connect the green wire to the Left speak-
er "Negative" wire.
Gray Wire:
Connect the gray wire to the Right speak-
er "Positive" wire.
White Wire:
Do not connect this wire. Tape it Off.
Blue Wire:
Connect the blue wire to the Right speak-
er "Negative" wire.
Warning !
1. Do Not Ground any speakers to the
frame of the vehicle or to any other
grounding system.
2. The fader control used in the M9050H
and radio can not be deleted. When
connecting two speakers to the unit,
use only the front set of wires provided
in the harness. Insulate the remaining
rear speaker wires provided in the har-
ness. (Tape the wires)
3. Do Not Connect the left front and left
rear wires together for any reason. This
will damage the unit.