Linear series am/fm stereo receiver and compact disc player, designed for in-wall installation of all recreational vehicles, motor homes and mobile housings 12 volts dc (13 pages)
Magnadyne Corporation or its authorized agents will within 1 year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.
M2080 English 08/04/00 7:51 AM Page 3 Controls and Operation TUNE POWER 1. Radio Tuning Knob 2. Power On/Off Button 3. AM/FM Band Button AM/FM FF/EJ Auto Stop Cassette STEREO TONE TAPE 4. Fast Forward/Eject Button 5. Tape Cartridge Door 6.
Page 4
M2080 English 08/04/00 7:51 AM Page 4 Controls and Operation 1. Radio Tuning Knob Rotate the radio tuning knob in either direction to select the desired AM or FM station. 2. Power On/Off Button Press the Power button to turn the stereo“On” or “Off”.
M2080 English 08/04/00 7:51 AM Page 5 Controls and Operation Radio Operation 1. To turn on the unit, push in the power button. 2. Select either AM or FM radio by using the AM/FM band button. 3. Use the radio tuning knob to select the desired station.
M2080 English 08/04/00 7:51 AM Page 6 Installation Dashboard Sheet Rear Support Strap Metal Screw Washer Figure 1 Mounting Sleeve...
Page 7
M2080 English 08/04/00 7:52 AM Page 7 Installation Slowly pull the keys out approximately 3/8”. This presses the two stoppers down and releases the unit. Release the rear support strap Insert the keys on the right and left side. Stopper Remove the end caps.
7:52 AM Page 8 Installation Space Requirements: To mount your new Magnadyne unit, you will need a rectangle hole in the mounting location 183mm (width) x 53mm (height), (7 ⁄ ”) and a full 7” of unobstructed space behind the mounting location.
M2080 English 08/04/00 7:52 AM Page 9 Electrical Connections Two Speaker Wiring 9-Pin Plug From Radio Red Wire Connect to Ignition 12V This unit if for use only with a 12 volt DC power source with a negative ground. If your vehicle is equipped with an antenna, connect the lead from the existing antenna to the antenna receptacle located on the rear panel of the unit.
Your M2080 will play C-30, C-48, C-60 and C-90 tapes. Avoid playing C- 120 or larger length tapes. These longer tapes create unwanted loads on the tape motor and belts causing pre-mature wear. Also, C-120 tape is thinner and prone to tangle inside the cassette mechanism, no matter how clean you keep your heads.