Table of Contents
Advertisement
3. Loosen the adjustment bolt; then remove the pivot
axles.
4. Rotate the tensioner pivot inward and remove the
track.
5. Place the new track in position.
NOTE: When installing a track, note the direc-
tional arrow. The arrow should be directed toward
the front of the ATV when viewing from the top.
6. Rotate the tensioner pivot outward to its original
position.
7. Install the pivot axles; then tighten the adjustment
bolt until a track deflection of 19 mm (3/4 in.) at 9
kg (20 lb) force is attained. Tighten the jam nut
securely.
ATV-1167A
Do not over-tighten the track or performance loss
ATV-1165
and/or component damage may occur.
NOTE: After 2-3 hours of operation on a new
track, check and/or adjust track tension.
Replacing Sprocket and Main Axle
NOTE: This procedure is appropriate for all four
sprockets and main axles.
1. Raise the ATV off the ground using a support
stand.
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the track (see Replacing Track sub-sec-
tion).
3. Remove the bolt and nut securing the anti-rota-
tional device to the frame.
ATV-1164
12
! CAUTION
! WARNING
ATV-1142A
ATV-1176A
Advertisement
Table of Contents
