Cabling; Wiring The Power Inputs - B&B Electronics Elinx EIR418-2SFP-T User Manual

Second, swivel the metal latch away from the switch and pull the transceiver out.

Cabling

Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable.
10Mbps: Use category 3, 4, 5 or greater cable
100Mbps: Use category 5 or greater
1000Mbps: Use category 5e or greater cable
Cable distances should be less than 100 meters (328 ft.) long.

Wiring the Power Inputs

Follow the steps below to insert the power wire.
1. Insert the positive and negative wires into the V+ and V- contacts on the terminal block
connector.
12
Pull out from the SFP module
Manual Documentation Number EIR418-2SFP-T – 0109m
Hardware Description
www.bb-elec.com
www.bb-europe.com