B&B Electronics Elinx EIR418-2SFP-T User Manual page 10

•
2 Gigabit Copper/SFP (Mini-GBIC) combo port:
The EIR418-2SFP-T has two auto-detect Giga ports—copper/Fiber combo ports. The
Gigabit Copper (10/100/1000T) ports should use Category 5e or above UTP/STP cable for
connection. The SFP slots support dual mode which can switch the connection speed
between 100 and 1000Mbps. These SFP slots can be used to connect the network segment
with single or multi-mode fiber. You must choose appropriate mini-GBIC module to plug
into the slots. Make sure the module is aligned correctly and then slide the module into the
SFP slot until a click is heard. With the SFP module (fiber optic connection), the switch can
transmits speed up to 1000 Mbps and you can prevent noise interference from the system
and get extended transmission distance, depending on the SFP module used.
Note The SFP/Copper Combo port can't both be used at the same time. The SFP
module has the highest priority. If a 1000M SFP transceiver is inserted into the
SFP cage and a remote device is connected to the SFP port, the copper combo
7
Straight Through Cable Schematic
Cross Over Cable Schematic
Manual Documentation Number EIR418-2SFP-T – 0109m
Hardware Description
www.bb-elec.com
www.bb-europe.com