Troubleshooting - Haier HLP141E User Manual

English
TRO U B L ESHO O T ING
Check your problem by using the chart below (If problems occur, please pull out
the plug before examining) and try the solutions for your problem. If the dryer
still does not work properly, contact Haier customer service center or the nearest
authorized service center.
Symptom
Dryer won't work
Dryer won't heat
Garments won't dry
enough
Drum won't turn (The
four indicator lights
of Cycle button are
on at the same time)
WARNING !
Never Overload the dryer.
Never put wet clothing washer spin cycle did not extract.
If troubleshooting is not resolved, unplug unit and call customer service.
Possible Cause
No power to machine?
Power plug not in the wall outlet?
Front door not properly shut?
Heating Temperature was not
set for Timed Dry?
Is temperature indicator LED
indicating "No Heat"?
Outside venting ducting is
blocked?
The exhaust filter is blocked?
Washer didn't extract enough
water?
Overloaded dryer with too
many garments?
Clothes not sorted to proper
cycle selection?
Is the front door closed?
Possible Remedy
Plug in Power Cord
Reset circuit breaker or
replace fuses
Close the front door
Press in the POWER or
START/PAUSE button
Reset the'Dry Temp' button till
the indicator light indicates
'High' or 'Low', and the LED
is on
Change Temp. settings to
High or Low: No Heat works
without heat
Make sure outside vent is
not blocked
Remove and clean Exhaust
filter
Make sure washer spin
cycle is operating properly
Reduce the amount of
garments loaded in dryer
Select the right drying cycle
for normal, heavy duty or
delicate laundry loads
Close front door and Press
the START/PAUSE button
18