Warning And Error Messages - Branson Digital Sonifier 250 User Manual

Operation

6.9 Warning and Error Messages

W h e n t h e s y s t e m e n c o u n t e r s a n e r r o r c o n d i t i o n , a m e s s a g e i s d i s p l a y e d o n t h e f r o n t p a n e l o f t h e D i g i t a l S o n i f i e r
u n i t a n d o n t h e r e m o t e c o m p u t e r o r t e r m i n a l i f o n e i s e n a b l e d . I f t h e k e y p a d i s i n l o c k o u t m o d e , m e s s a g e s w i l l
a p p e a r o n l y o n t h e r e m o t e c o m p u t e r o r t e r m i n a l . T h e f o l l o w i n g t a b l e d e s c r i b e s t h e p o s s i b l e e r r o r a n d w a r n i n g
m e s s a g e s , t h e c o n d i t i o n s t h a t c a u s e t h e m , a n d t h e a c t i o n s y o u s h o u l d t a k e w h e n t h e y a r e d i s p l a y e d .
Table 6-5: Warning and Error Messages
Message
Value out of range
Are you sure you want to
overwrite?
Printer error
THE DATA FORMAT
ENTERED FOR parameter IS
INCORRECT! PLEASE
ENTER AGAIN.
INVALID COMMAND
RECEIVED, PLEASE ENTER
AGAIN.
THE SYSTEM COULD NOT
INTERPRET THE LAST
TRANSMISSION. PLEASE
TRY SENDING AGAIN.
6-44
Cause
You entered a parameter
value that was outside
the parameter's limits.
You tried to save a set of
parameter values under a
preset ID that is already
in use.
You issued a print com-
mand, but there was no
response from the printer.
The system was turned
on with the 'Printer = On'
but with no printer con-
nected.
The parameter value that
you entered was in the
wrong format.
You entered an invalid
command through the
remote computer or ter-
minal.
The system could not
interpret the data that
was sent from the remote
computer or terminal.
Take This Action
Press Enter. The parameter becomes
available so that you can re-enter a correct
value. Refer to Table 6-1: 'System Setup
Parameters' on page 6-9, and Table 6-2:
'Operation Parameters' on page 6-26, for
the limits for specific parameters.
To overwrite the existing values in the Pre-
set ID, press Line Selector key #3. To
enter a different preset ID, press Line
Selector key #4. The previous screen is
displayed for you to enter a different pre-
set ID.
Check that the printer is correctly con-
nected and turned on. Check the Model
parameter to see that the correct printer
model has been set. Check that the Printer
parameter is set to On.
Enter the value in the correct format. Refer
to Table 6-1: 'System Setup Parameters'
on page 6-9, and Table 6-2: 'Operation
Parameters' on page 6-26 for valid param-
eter formats.
Enter a valid command. Refer to
Table 6-2: 'Operation Parameters' on page
6-26 for valid remote terminal commands.
Send the data again.
100-214-239 Rev. A