Panasonic CS-E9SD3UAW Service Manual page 39

Mounting Remote Controller Receiver
Install the remote controller receiver cable at least 1 31/32" (50 mm) away from electric wires of other appliances to avoid miss-operation
(electromagnetic noise).
1 Remove the bottom case.
Attention
Mounting the bottom case

Tighten the screws securely until the screw heads
touch the bottom case. (Otherwise, loose screw
heads may hit the PCB and cause malfunction
when mounting the top case.)

Do not over-tighten the screws. (The bottom case
may be deformed, resulting in fall of the unit.)
Connecting the remote control wiring

Arrange the wires as shown in the illustration for 2 as in diagram below, avoiding unnecessary wires being
stored in the case. (Caught wires may destroy the PCB.)

Avoid wires touching parts on the PCB. (Caught wires may destroy the PCB.)
2 Mount to the wall.
EXPOSED TYPE
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
• Align the claws of the
top case and then align
the claws of the bottom
case.
Cut here with
a nipper and
remove the burr
with a fi le.
Claw (2 places)
Claw
Wood screw (supplied)
Connect the remote control wiring.
• Arrange the wires along the groove of the case.
Top case
(Back side)
Bottom case (Back side)
Mount the bottom case
to the wall.
Wall to fi x the
receiver
Hole for screw
7
Clamper
(supplied)
Pass
through
the hole
Insert the driver
and slightly turn.
Bottom Flat-blade
case screwdriver
Screws
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
• Align the claws of the
top case and then
align the claws of the
bottom case.
Avoid the wire
being caught.
Claw (2 places)
Wood screw (supplied)
Connect the remote control wiring.
Bottom case (Back side)
39
6
EMBEDDED TYPE
Mount the bottom case to the wall.
• Pass the wire through the hole in
the centre of the bottom case.
Claw
Hole for screw
Terminal board
Top case
(Back side)