Rear Panel - Blackstar ID:CORE STEREO 100 Owner's Manual

Rear Panel

1. Power Switch
This switch is used to turn the amplifier on and off.
2. Mains Input
The supplied detachable mains lead is connected here. Always ensure the Power
Switch is in the OFF position before applying mains power. The lead should only
be connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt get advice from a
qualified technician.
3. Emulated/Headphone Output
This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural tone for connection to a recording device or mixing desk. To
make full use of the stereo effects, use a stereo jack to two mono jacks splitter lead
to feed two channels of the recording device or mixer. The output will also function
into a mono guitar type lead. Always use a good quality screened lead. Turning the
Volume knob (4) will control the Emulated Output level. The Master Volume knob
only affects the internal speakers.
NOTE: To 'silently' record or practice via headphones, set the Master Volume to
zero.
4. MP3/Line In
Connect the output of your MP3 or CD player here. Adjust the player's volume to
match that of your guitar to enable you to play along.
5. Footswitch
Connect your included FS-13 footcontroller here, or any other compatible Blackstar
footcontroller (e.g. FS-12 programmable footcontroller). See the Footcontrollers
section on pages 16-17 for more information.
6. Effects Loop
In addition to using the studio quality effects within your amplifier, you can place your
own external effects processors and stomp boxes 'in the loop' for the best sonic
performance. Connect the amplifier 'Send' to the input of your effects unit, and
connect the output to the 'Return'. If your effects unit has a stereo output, connect
to both 'Return' sockets on your amplifier. If your external effect is mono connect
the output of your effects unit to only the 'Return L (Mono)' socket.
Programmability
Storing Patches
To store the current sound as a Patch:
1. Press and hold any of the three Channel switches (19) for one second. All three
Channel LEDs will begin to flash.
14