Blackstar ID:CORE STEREO 100 Owner's Manual page 13

18. Bank
Press the Bank switch to scroll through the first three banks of patches.
Bank 1 -> Bank 2
Bank 2 -> Bank 3
Bank 3 -> Bank 1
The green LED indicates you're in Bank 1, the orange LED indicates you're in Bank
2 and the red LED indicates you're in Bank 3.
NOTE: The first three banks can be selected from the front panel. When you activate
Bank 4 and higher from an external controller (e.g. Blackstar INSIDER software,
footcontroller), the Bank LED will not be lit but the channel LEDs will continue to
show you the patch location. For example:
Patch 9 – Bank LED red, Channel 3 LED lit.
Pressing Bank UP from an external controller will switch you to Patch 12 – Bank
LED off, Channel 3 lit.
The channel will be remembered, therefore the corresponding patch within the
current bank will be loaded when scrolling through the banks.
When the amplifier is in Manual Mode, the Bank LED will not be lit.
19. Channels 1-3
Channel 1 activates the first patch within the currently active bank.
Channel 2 activates the second patch within the currently active bank.
Channel 3 activates the third patch within the currently active bank.
20. Recall Indicator
The Recall Indicator shows if there is a mismatch between the current value of a
parameter within the amplifier and the corresponding physical front panel control.
For example, when you change to a different patch the controls on the front panel
may not always reflect the setting you are hearing.
To prevent unexpected level jumps in the control you are adjusting, the front panel
knobs will have no effect on the sound until the knob reaches the current parameter
value. Once reached the Recall Indicator flashes twice and the knob 'takes control'
of the value and can increase or decrease the value.
The recall indicator will flash each time the physical knob 'passes through' the
currently active value that you are hearing.
Recall is active for Gain, Volume, Bass, Middle, Treble and ISF.
When the Tuner is active the Recall Indicator will flash continuously.
When looping, the Recall Indicator will flash once to show when the currently playing
loop has restarted. When a loop or overdub is being recorded, the Recall Indicator
will flash continuously.
13