Related Manuals for Blackstar ID:CORE STEREO 100
Summary of Contents for Blackstar ID:CORE STEREO 100
- Page 1 ID:CORE STEREO 100 & ID:CORE STEREO 150 Owner’s Manual Designed and Engineered by Blackstar Amplification UK...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. 8. - Page 3 Before switching the unit on, it is recommended that the unit be allowed to reach room temperature. According to OSHA, any exposure in excess of the above permissible limits could Unauthorised modification of this equipment is expressly forbidden by Blackstar result in some hearing loss. Amplification Ltd.
-
Page 4: Features
Patches can be shared, uploaded and downloaded via the online community. The If you like what you hear and want to find out more about the Blackstar range of USB connector also allows you to record from your amp directly to your computer. -
Page 5: Factory Reset
Factory Reset Front Panel The default factory patches and settings can be restored to your amplifier at any 1. Input time. Simply hold down the MOD, DLY and REV switches simultaneously, whilst Plug your guitar in here. switching on the amplifier. Always use a good quality screened guitar lead. -
Page 6: Effects Table
7. Volume 12. Effect Type This controls the preamp volume. High levels of volume will introduce the effect of This changes the effect type and edits a parameter of the currently ‘focused’ effect valve power amp distortion and compression. This setting is saved when you store (modulation, delay, or reverb). -
Page 7: Tuner Mode
19. Channels 1-3 While in Manual Mode any of the controls can still be modified by the Blackstar Channel 1 activates the first patch within the currently active bank. -
Page 8: Programmability
In addition to using the studio quality effects within your amplifier, you can place your The output of the audio over USB can be changed via the Blackstar INSIDER own external effects processors and stomp boxes ‘in the loop’ for the best sonic software, and can be one of the following: performance. -
Page 9: Footcontrollers
FS-13 Looper Mode section above. To change this default setting, connect USB cable is removed, or when the amplifier power is switched off. the amplifier to your computer via USB and use the free Blackstar INSIDER software When activated, Reamping Mode allows the amplifier to accept a pre-recorded, dry to make your personal selection from various options such as Modulation/Delay/ guitar signal via USB and return a fully processed audio signal. -
Page 10: Advanced Features
Resonance – Tap + Bass When the amplifier is connected (via USB) to a version of the Blackstar INSIDER The Resonance control sets the overall bass response. At lower settings the cleans software containing newer firmware, a message will be displayed prompting you will be tight and funky and overdrives will be focused in their bass response. -
Page 11: Front Panel
ID:CORE STEREO 100 Front Panel BANK ID:CORE STEREO 150 Front Panel BANK... -
Page 12: Rear Panel
ID:CORE STEREO 100 Rear Panel EM. OUT & PHONES 100V - 240V~50/60Hz 130 WATTS LEFT RIGHT (MONO) T1.6AL250V SEND RETURN ID:CORE STEREO 150 Rear Panel EM. OUT & PHONES LEFT RIGHT (MONO) SEND RETURN... - Page 15 For the latest information go to: www.blackstaramps.com Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement and development, Blackstar Amplification Ltd reserves the right to alter specifications without prior notice.
Need help?
Do you have a question about the ID:CORE STEREO 100 and is the answer not in the manual?
Questions and answers