Blackstar ID:60TVP-H Owner's Manual
Hide thumbs
Also See for ID:60TVP-H:
- Owner's manual (57 pages) ,
- Owner's manual (50 pages) ,
- Owner's manual (14 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Blackstar ID:60TVP-H
Summary of Contents for Blackstar ID:60TVP-H
- Page 1 Owner’s Manual Designed and Engineered by Blackstar Amplification UK...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. 8. - Page 3 Warning! Never disconnect the protective mains earth connection. High loudspeaker levels can cause permanent hearing damage. You should Important safety information! therefore avoid the direct vicinity of loudspeakers operating at high levels. Wear READ THE FOLLOWING INFORMATION CAREFULLY. SAVE ALL hearing protection if continuously exposed to high levels.
- Page 4 Introduction Features Thank you for purchasing this lackstar ID eries amplifier. ike all our products, this In the five years since its launch, lackstar has led the way in the innovation of guitar amp is the result of countless hours of painstaking Research and Development by amplification.
-
Page 5: Demo Mode
Demo Mode Factory Reset When the ampli er is rst switched on after purchase, or after a factory reset, it will The default factory patches and settings can be restored to your ampli er at any be in Demo Mode’. The sound you hear will re ect the physical position of the front time. -
Page 6: Front Panel
Front Panel As the treble control is increased clockwise the sound will become brighter. At the maximum settings the sound will be aggressive and cutting. This setting is saved when you store a patch. 1. Input Plug your guitar in here. Always use a good quality screened guitar lead. 8. - Page 7 Effects The Effects Table below shows the modifiable parameters Up to three studio quality effects can be switched on at any time. This setting is saved when you store a patch. 11. MOD (Modulation) 16. Tap Press this switch to turn the modulation effect on, off, or focus the effect for editing. The Tap button is used to set the rate/time of the current ‘focused’...
-
Page 8: Master Volume
18. Presence The Manual, ank and Channel EDs will indicate the closest note to the note being played. The Presence control sets the overall treble response. Percussive high-end can be accentuated on clean sounds and the amount of aggressive treble controlled with crunch and overdrive settings. - Page 9 24 – 27. Channels 1-4 toring a patch will overwrite any previous patch in that location. Channel 1 activates the first patch within the currently active bank. Patches can also be stored via lackstar’s Insider software or a connected lackstar F -10 footcontroller.
-
Page 10: Rear Panel
Footswitch latched ON (e.g. ED illuminated on the F -4 activates Channel 2 2. Speaker Outputs ID:60TVP, ID:100TVP Blackstar FS-10 Footcontroller There are two parallel speaker outputs for connecting external speaker cabinets. This multi function footcontroller allows you to access all patches, toggle effects The minimum load is 4 Ohms. -
Page 11: Technical Specification
- eft – effected amplifier signal MIDI footcontroller - Right – unprocessed guitar signal Re-amping Mode ID:60TVP-H Re-amping Power: 60 Watts The amplifier can be switched into Re-amping Mode via lackstar Insider software. This is a non-storable setting and will be switched off either when the U cable is Weight (kg): 10.8...